Today was a pretty good day to work on the car so I took advantage of the sun and got the box in. I still need to put all the bolts back into the bellhousing, but the heavy lifting is now over and now I just needs to bolt/plug everything back in.
Got lucky with the clutch as I aligned it by eye and the box slid straight in. So glad it didnt screw up and require me to remove and re-align.
Pics
After removing the torque converter.
Notice the difference between the manual and automatic cranks. The manual has no pilot bearing and the automatic does. The manual also has no provision for a bearing so im not sure if you could automaticalise a manual car without changing the crank. Also take note of the alignment dowel which prevents you from installing the flywheel on in the incorrect orientation.
Auto:

Manual:
The next new thing I learn't was the use of M12 Spline bolts on the manual flywheel. It looks like its a specific type of bolt only used with the dual mass flywheel. I had to run down to the tool shop to grab myself the proper bit as I didnt already have one.
Here you can see the Auto vs Manual bolts. The auto one is the 12 tooth bolt and the Manual one is the splined bolt.
Then I gave it all a good clean and bolted it to my engine. Didnt have a clutch aligntment tool and because there is no pilot bearing an extension was no good so I decided to try my luck and do it by eye.
Then lucky for me some help arrived and we were able to lift the box back into place.
A storm was threatening to wash us out so we decided to pack up for the day. All in all im happy with our progress. Tomorrow I will be putting everything back together and hopefully putting it back on the ground.