240 Parts, South East Melbourne.

Samman88

Hi all,

Getting rid of a spare shell and drivetrain, all parts are cheap or free.

Running gear from a 1980 244.
Driveshaft with new unis and centre bearing, $50.
Any B21 KJet parts, new dizzy cap etc, Cheap.
244 new rear shocks, $40.
Any brake system parts, proportioning valve etc, Cheap.
Starter, Alternator $20 each.
Full late model 240 vented brake setup, girling front and rear calipers, discs, pads, new front brake lines, $200.
BW35 Auto, $20.
Front Struts, any suspension parts, $20.
5x 14” steelies with old tyres but hold air, $50 the lot.

I am also scrapping a 1987 wagon shell. Any panel cuts or rust repair cuts available cheap before it goes to scrap.

Any other parts required, please enquire below.

RateatCat

Samman88 Very much interested in the starter and alternator. If Ex hasn't already I may keen on the front brakes as well.

Thanks!

Ex850R

Hej, I’m keen on driveshaft and rear shocks please, maybe front brakes but I’ll check which I have first.
Message me? Les

Ex850R

RateatCat
You grab the brakes, I’m pretty sure my early wagon already got new fronts done by my retired Greek mechanic, it’s a real work in progress…..

Ex850R

Probably the BW35 as well, my man is old skool hotrodder and will build me a strong one!

Ex850R

Is the rear hatch on shell good for 1976?

Samman88

Thanks guys, I’ll PM you both this afternoon.

@Ex850R the wagon hatch is from an 87 wagon, I think it may be different from the really early ones, but it does have some rust in it.

dmc

Hi, is the warn up regulator working Ok? It is the small box behind the distributor with a 2 pin electrical connector and two banjo bolt fuel lines connected to it.

Samman88

@dmc I’m not 100% sure to be honest. It ran and drove ok but not as well as it could have, and I’m not sure what was and wasn’t working. You’re welcome to pick through the kjet stuff or I can send it too you for the postage cost.

dmc

Thanks, will PM.