VXDiag Nano turned up yesterday. VDash has been connected, first task to reset the SRI complete. Will do some more research over the next couple of days before trying to crack the CEM over the weekend to update for the dash.

The updated shifter came yesterday so will have a look at putting that in along with the suspension while VDash is doing it's thing.

So connected the VXdiag and fired up Vdash. 14days to crack the pin so might have to wait until I have a better internet connection connected and a Dice

Also got the fresh suspension in.

Anyone want some RD suspension?

The vxDiag will crack CEM in a few hours on average it seems.

I don't think a dice can do it.

Funny, the Vdash guys recommendation is Dice over VXdiag.

    Nelpd96

    Funny, the Vdash guys recommendation is Dice over VXdiag.

    Ahh, I'm thinking (or not!) . VDash I forgot, no brain, not enough sleep!

      I missed it, what discs and pads have you put in?

      You'll be pleased with the H&R springs for sure. Did you opt for Bilstein B8 or B6 for it?

      Got the kit with the B8 from FCP. It is firm but not too bad with the 18' rims.

        Nelpd96

        Got the kit with the B8 from FCP. It is firm but not too bad with the 18' rims.

        Going to 19" for a while then back to 18" with 245/40/18 Ps4s is a revelation! The old Dunlop 19" on Jaguar rims were so bad it sounded like a wheel bearing had gone, comfort was all jiggly and hard.

        This is on newish R-Design suspension, could do with a top of the range set of dampers on front for the propensity to push the nose.

        I'm sticking with Michelin from now on......

          Nelpd96

          Got the kit with the B8 from FCP. It is firm but not too bad with the 18' rims.

          The B8s are very good. We sell quite a lot of them. They're serviceable as well.

            The chrome trim looks ok on a red car.

            Red mirror cover much better!

            Car is booked for front seat belt recall and CANBUS update on 29 March. Just need to see if I can crack the CEM now that I have a Dice in the house.

            Still waiting on the Android Auto unit to arrive and then i will put that in as well as the update shifter and that should be me just about done.

            11 days later

            CEM and ECM crack went well, no issues. Software update done today $185 for those playing at home. Will proceed with VDash install of the TFT on the weekend and assuming that goes well with probably follow up with the flash tune.

            Still waiting on the AA unit.

            Any tips for removing the trim clips on the boot lining so I can install this reverse camera in prep for when the AA turns up?

            © 2013-2023 Oz Volvo. All rights reserved. | Forum Rules | Privacy Policy