Slowbrick
Yeh cam is plugged into the orange plug. I'll take the manual cps and try that tomorrow I suppose.
Slowbrick
@rob
Rob
is it cranking with the key?
Slowbrick
Yeh it cranks with the key but doesn't catch.
Rob
How did you get that to work? Did you join the green and green/red wires at the trans plug?
Slowbrick
I made a jumper lead from the starter to what I read somewhere as being a "service plug" in the fuse box.
Rob
Mmmm. never heard of that one. If you go to the plug that used to plug in to the PNP switch and pull the wiring out of the conduit. You will need to cut 4 wires. Green, Green/red, Blue and Blue/grey. join the green and green/red wires, that will allow the starter to crank. The blue and blue/grey wires are the 2 wires that run to the reverse light switch.
Once you have done that, provided everything else is plugged in, the only thing that can cause any problems is the pickup for the flywheel. The polarity may need to be reversed, although I believe it will still start if it is wrong, it just affects timing. Are they both '98s?
Rob
Oh, have you removed the Transmission computer?
Slowbrick
Ok ill try the pnp switch tomorrow. The flywheels both had square notches and had a dowel for alignment. I haven't removed the transmission computer yet. Will that cause a no start situation?
Rob
Flywheel/sensor should be right. Not sure if the Tranny computer will prevent it from starting but it may, some say it wont start with it still installed. I would do the wiring mod and remove the ECU and see what that does before i went any further..
Jamest5r_
There is a.pic of the wiring you need near the bottom of this link in the 1st post I can't copy and paste the pic on my phone for some reason
http://www.volvoforums.org.uk/showthread.php?t=71697
Jamest5r_
Worked it out :)
Slowbrick
Thanks guys. I'll try it tonight when I get home from work. Hopefully its a simple fix.
Slowbrick
Came home at lunch and had a go at it. Tried everything that was suggested. Turns out the pickup was cracked and after a few attempts at changing plugs it fired right up! Now I need to bleed the brakes and go for a spin!
jamesinc
Can you bring it to mine when you're in Sydney and we can take BFF photos?
Rob
Slowbrick;36191 wroteCame home at lunch and had a go at it. Tried everything that was suggested. Turns out the pickup was cracked and after a few attempts at changing plugs it fired right up! Now I need to bleed the brakes and go for a spin!
nice.
Ex850R
Good job!!
A very focussed half hour with all knowledge helps in diagnosis!
Happy trails!
Slowbrick
It idles crappy cause the crappy vac hoses are broken. I'll replace them tonight. Keen to go for a drive!
AshDVS
Great work man!
Slowbrick
Well tonight was quite eventful. First thing that caught me out was a relentless radiator leak at the bottom hose. I swapped hoses and it still leaked. Turns out the bottom tranny cooler barb was still attached to the tranny. I popped it back in and it stopped leaking.
Second surprise was as I backed out the driveway it stopped moving. I thought the clutch needed bleeding more but it still didn't work. Turns out the passenger cv had popped out. I gave it a good push and it seemed to clunk into place better.
After all this I went for a drive around the block and i didn't catch fire.