Note: Bottom end developed a metallic knock - sounded like a bend rod or end bearing on idle. The cause was from a internet ECU flash trial spin around the block, heard the noise came back home and parked it.
This is dads S70 so i had the motor promptly replaced with a HTP 2.3 01' RN motor.
The head is near new covering less than 10kms, the head was fully reconditioned at Yennora with new valve seals, cleaned and tested for flatness/true levels.
The engine has covered 236K when it was pulled, the timing belt, tensioners, idlers have also covered less then 10K.
Asking for $250. I can borrow an engine hoist locally if required, you will need to organise your own transport for it though.
This is dads S70 so i had the motor promptly replaced with a HTP 2.3 01' RN motor.
The head is near new covering less than 10kms, the head was fully reconditioned at Yennora with new valve seals, cleaned and tested for flatness/true levels.
The engine has covered 236K when it was pulled, the timing belt, tensioners, idlers have also covered less then 10K.
Asking for $250. I can borrow an engine hoist locally if required, you will need to organise your own transport for it though.
