nugget_940 Hey all, just wondering where the best placeis to get bearings and seals to rebuild a 1031 diff.Scored a 3.73 and also purchased a 4wd systems lokka for it.Chur
Philia_Bear I think the timkin part numbers you need for the diff bearings are posted on turbobricks article section this includes thd pinion bearingThe axle seals are out at the wheel bearing ends, Pinion Seal SKF 942905
Angus242164 I'm not familiar with the Lokka, but I installed a Powertrax Lockright locker in a 1031 rear end, and as it fits inside the original carrier in place of the spider gears of the open diff, there is no need to replace any bearings.
nugget_940 Angus242164 I'm not familiar with the Lokka, but I installed a Powertrax Lockright locker in a 1031 rear end, and as it fits inside the original carrier in place of the spider gears of the open diff, there is no need to replace any bearings.Same same.The diff I picked up leaks like a sieve. Not going to go through the effort of swapping an entire rear axle with a leaky rear axle and new centre.
Angus242164 Fair enough, a pinion seal, pair of axle seals and a cover gasket should cover all the leakage points.
Philia_Bear Angus242164 Fair enough, a pinion seal, pair of axle seals and a cover gasket should cover all the leakage points.This