The forums were recently upgraded, and this may alter behavior or break things. If you notice problems, check and report them in this thread

[SOLD] M46 Gearbox with working overdrive - $300

240240 (@240) Canberra
edited July 5 in For sale
M46 gearbox for sale.
Overdrive works well, plus I have a spare working overdrive that can be included by negotiation (or I can sell it by itself if you just need an OD).
It has the fine spline input shaft so can be used on later 240's no problem.
Bellhousing has the cutout for the LH2.4 crank position sensor, although I don't think it will be a problem using it on non-LH2.4 cars.
I have the front tailshaft section and crossmember as well, if required.

It's not 100% perfect - I found that shifting from 3rd or 4th down to 2nd could be somewhat difficult and notchy, and not as smooth as it should be, and occasionally the 3rd to 4th shift was a bit rough.
However, the gearbox has been in my daily driver car for over 2 years so is definitely still usable.

Price is $300 and can be negotiable, particularly if you only need the box but not the other bits, but I am losing money on it either way so no ridiculous low-ball offers.
Located in Canberra.

---NOW SOLD---

Comments

  • 240240 (@240) Canberra
    Happy to take $150 for just the gearbox, and can also sell the other bits separately if required.
    Forgot to mention that I also have the overdrive wiring and relay.
  • RobRob (@Rob) - Lockyer Valley, SE Qld
  • How much for the Bellhousing?
  • How much for the Bellhousing?

    Its free, when you buy the gearbox for $300
    Rob
  • 240240 (@240) Canberra
    I'm reluctant to remove the bellhousing because it will make the box hard to sell.
    If you're desperate, I could be tempted for the right price, say $100 plus postage.

    To be specific, the other bits that I have in addition to the gearbox itself are:

    Front tailshaft section (with near-new centre bearing on it)
    Crossmember
    Spare overdrive (working)
    Overdrive wiring and relay
    Shifter (with OD button and wiring)
    2x mounts (used)
    2x aluminium spacers (for between the crossmember and chassis)
    Potentially some other small bits and pieces that I can't remember
  • 1971_144GL1971_144GL (@1971_144GL) Launceston, Tasmania
    I am interested in the spare overdrive depending on the postage cost to Tas. Any idea of the weight?
  • 240240 (@240) Canberra
    It's fairly heavy, but probably not impossible, I'll look into it.
  • 240240 (@240) Canberra
    Bump for photos

    slzm4zk9le7z.jpg
    8ks3lmy3gd6o.jpg
    obs6n10pvpih.jpg
    uhxvuzwtjh3h.jpg

    (spare overdrive not pictured)
  • 240240 (@240) Canberra
    Turns out I have a spare rear tailshaft section too.
    So there's probably enough here to get you half way to a manual conversion.
  • jackafricaricho (@jackafrica) Hobart Tasmania
    Definitely interested in the spare working overdrive.
    Sent a PM
This discussion has been closed.