240 auto to manual flywheel help

pigdog

Hey guys finally pulled my finger out and started the manual conversion just need a little help with the flywheel.
my 240 is a 1990 with the crank angle sensor but im using an older M46 box so i need a flywheel to suit .
this is abit out of my knowledge and skill level so i need help lol
ive been told i need a flat flywheel to suit the M46 but i need holes drilled for the cas
ive contacted TTV racing to enquire about their flywheels and have noticed sts machining have this flywheel available aswell ......
https://www.stsmachininginc.com/products/copy-of-lh-2-4-20-lbs-flat-flywheels-notched-60-2-redblock-240-740-940

can anyone shed some light if this one will work or have some other options for me (cheaper and in oz would be ideal)
i would prefer not to have to buy a new one and spend a fortune considering the car itself only cost me $50 and the gearbox another $50 but if i have no choice then i have no choice ..

im also looking for the last couple things i need for the conversion being the lines and brackets from the master to slave and slave itself and an m46 shifter if anyone is selling them let me know
ill also make a wanted ad for these parts though.

pretty keen to get onto this asap the pedals are in and clutch master is in i just need the rest so i can finish it up.

cheers guys

Philia_Bear

You can use the dog dish lh2.4 flywheel with the early m46
It was iirc only the m45 that ever came with the different spline count input shaft and even with it you can use the dog dish but just with a custom clutch instead of a std clutch

pigdog

Ok sweet ive found a bloke with LH2.4 flywheel , clutch slave and all lines, crossmember and m46 shifter for $250
so im jumping on that if for some reason it falls thru ive found another bloke with a predrilled flat flywheel for $280
and if all fails ive got a bloke that can drill a flat flywheel to suit so i have some options !!