Pair of King KVFL-08 lowering springs to suit the front of 7/9 series. In good condition, have had very little use. Looking for $100.
King front lowering springs for 740/940
do you have pics of them fitted
These are Kings all round with Koni shocks on mine. Standard 15 inch stockies 
Unfortunately I can't find any decent photos, so this is the best I have:
its about what ive got at the moment want lower
What springs do you have at the moment? They're definitely lower than stock, though unfortunately there isn't anything lower available unless you go custom.
Once you go any lower on a Seven or Nine, you run into all sort of problems with bump steer, etc., and then you need to do more work on the front end.
https://www.kaplhenke.com/products/700-900-quick-steer-roll-correction
https://www.kaplhenke.com/products/700-900-adjustable-swaybar-endlinks
These cars are extremely sensitive to ride height changes / differences.
https://www.kaplhenke.com/products/700-900-quick-steer-roll-correction
https://www.kaplhenke.com/products/700-900-adjustable-swaybar-endlinks
These cars are extremely sensitive to ride height changes / differences.
They aren't that bad! Another 15mm lower than that and I have no issues. Arms are parallel.
They really don't go that low, I wouldn't recommend them ! :lol: :lol: 
You've done something wrong!
Factory springs subtract an engine and a gearbox!! Its got positive camber thats how high it is! :lol:Vee_Que;117728 wroteYou've done something wrong!
I mean that mere morals like me, not experienced mechanics handy with a lathe like you, could run into issues.Vee_Que;117714 wroteThey aren't that bad! Another 15mm lower than that and I have no issues. Arms are parallel.
had them made just have to go again
No, I don't have access to a lathe often unfortunately . I literally fitted king low springs, but have been using bilstein hd springs so it sat higher and I had them reset to be a tad lower. Have sach shocks right now so will be lower again annoyingly, but will not be much lower than the control arm height.bgpzfm142;117752 wroteI mean that mere morals like me, not experienced mechanics handy with a lathe like you, could run into issues.Vee_Que;117714 wroteThey aren't that bad! Another 15mm lower than that and I have no issues. Arms are parallel.