AshDVS Hi all, I have two sets (pairs) of 32mm wheel spacers and long wheel studs so that you can mount FWD wheels on your 240/740. They're spacers, not adaptors and come with 3" long ARP racing wheel studs. They're hubcentric and will fit on the front or rear. Standard 240 wheels are ET20, most 850 and x70 wheels are ET43, so if you use these with 850 wheels, you'll have a net offset of ET11. Wider track, guards are better filled out etc. Spacers were all purchased at the same time. They have had minimal use but have some discoloration from washing, brake dust, heat, etc Set #1 - 2 spacers and 10 studs. $220.00 Set #2 - 2 spacers and 10 studs (5 studs are brand new and have not been used). $230.00 Or take the lot, including 19 used studs and 10 brand new studs for $400.00
Ex850R Can i put dibs on the used set of 2? I have S2 S40 rims and they are more offset than the std V70 P1 so i may need 32mm for the rear , can i get back to you when i get a chance to check? L.
AshDVS They might be ok for that. P2 C30/S40/V50 are 55mm offset (maybe up to 58mm or so on some wheel designs), so a 32mm spacer should have you wind up with around 23mm offset - this will push the wheel out in the guards a bit more. It'd probably look pretty good in the rear. Centrebore dia is 63.4mm and the 850 and P1 x70 uses 65.1mm so you'll need the wheels machined to the earlier centrebore dia - most wheel places can do this for you as they make a squillion out of kids putting VE commodore wheels on their VL commodores who need the same thing done. I'm keen to move them on fairly quickly, drop me an email if you need them and I can pop a set in an express post satchel and have them on their way. Cheers, Ash
AshDVS I'm keen to get rid of them as there is no point them sitting around, pricing revised as follows - Set #1 - 2 spacers and 10 studs. $170.00 Set #2 - 2 spacers and 10 studs (5 studs are brand new and have not been used). $180.00 Or take the lot, including 19 used studs and 10 brand new studs for $300.00