Hi there, does the 200 series panels boot lid, doors and bonnet fit my 240 GT.
Short answer is yes, they are essentially the same from the A pillar forward and C pillar rearward.
The 200 was produced over 15 years in 3 different versions with many variants of each though so we will probably need to know exactly which 200 series you are talking about to give you a better answer.
Ok thanxs Rob will get back to you
Excluding doors, 2 door doors are bigger. As Rob said, A pillar forward and C pillar rearward.
It's mainly the bonnet I wish to replace
From a 1990 244 DL
You are out of luck. 1990 bonnet won't work. They are different at he cowel panel under the windscreen.
It will physically fit on.
However the rear edge will look rubbish as rob said and the grille is different between the two.
If you desperately need one then it stops the engine getting wet, but best bet is to hunt around a bit till you find the correct one (pre 83 from memory)
Stuart, this page will give you a better idea of what fits what cars. k-jet.org/articles/information/200-front-end-options/
Pre 86 is the same scuttle panel actually.
Who wants to do a post 86 swap 0_o everyone screams for flat hoods.