1997 model series 1 c v driveshaft problem.I found out( the hard way).The right hand c v axle is locked on the inner spline by 2 roll pins.When replacing the axle I installed a new pin of the same diameter which got totally jammed part in.Which could not be driven out( with roll pin punch) So had no alternative than to snap off and drive a pin part in from other side and snap off.Had tryed to drill out with hardened lubed drill bit and got nowhere.Have been driving it this way for 2 years with absolutely no problems.Any suggestions on how to remove these jammed in roll pins,without resorting to heat and start boiling grease and destroying seals??