Hi.
noticed a bit of a knock on the rear whilst going over bumps the other day.
had a look today and discover a “missing bolt” that runs through the bush in the k frame in to the back of the diff housing.
no dramas o work for a Volvo truck wreckers. Found correct bolt messed around aligning the diff and it just wont go in!
upon further inspection, the bolt has snapped Aprox 2mm inside the hole.
this looks like fun?
any suggestions on getting at the left over bolt?
looks like…
drop exhaust.
drop k frame
ptobably tail shaft too.
unbolt diff centre from frame and either drop or lift diff centre enough to gain access.
that way, I can break an easy out in there and make life even harder!
anyone had any experience doing this?