850 Parts needed - or where to buy them

Brehon47

Gents ors
I have never ordered parts for my vehicles from overseas but suspect I should asap.
I want new genuine or OEM parts but where best should I head?
FCP - Skandix - IPD (USA) -Mick;s garage (Ireland) -or ebay ? Not interested in Fabrique en Chine!!
Trivett's Parramatta are horrendously expensive and cavalier regarding customer service.
My vehicle is an 850 1996 20v NA auto Estate VIN: YV1LW5506T2203736 Engine: B5254S601491
I need:
drivers side rear vision mirror (mirror only)

RH ball joint
ABS unit
RH & LH tie rods & ball joints

Any advice - or local source - would be welcome.
Tiny

timbo

Sandwood trading in Melbourne
( 03 9898 0314) will have all of that apart from abs, which you would simply have the module repaired by someone competent like these guys https://www.absrepair.com.au/

Ex850R

Do an exchange abs unit. If the guys above don't the Midwest Abs in USA do, great guys to deal with.
Rockauto is good to order from. Fcp as well. I haven't gone with ipd for a long time, I found to much there was more expensive than I got from those other two. Partsforvolvo online (PFS) in up are good too.

Brehon47

Thank you both. Tiny

94_850_t5

I second Snoopy on Rock Auto. Fast and relatively affordable freight to AU which is always a good thing!

rado

Abs unit , what are you after Tiny ? Is this any good for you ?

This is from a 96 850 wagon 20v na auto .

Brehon47

Stevo - should be as my 850 is the same specification. Assuming its working whats it worth? Tiny

rado

Brehon47;c-161052 wroteStevo - should be as my 850 is the same specification. Assuming its working whats it worth? Tiny

I bought the car for spares , drove the car onto trailer , then from trailer into my shed with no warning lights on , so should be good , the two wires are a bit crusty .....
I can post it to you no problem , pay the post and go from there if you like , i'm not after much $ at all as it'll never fit my 850 .
PM me if you are interested

cheers Steve

Jamest5r_

You only need the top part, undo the 4x torx bolts and you're good to go